Toshiba B-EX4T1 Series Owner's Manual page 20

2. PRINTER SETUP
2.3.1 Loading the Media
(Cont.)
NOTE:
Do not over-tighten the Locking
Ring of the Supply Holder.
7. Align the projection of the Supply Holder with the groove of the
Supply Shaft, and push the Supply Holder against the media until the
media is held firmly in place. This will centre the media
automatically.
Then turn the Locking Ring clockwise to secure the Supply Holder.
In the case of a label rolled with
the print side facing inside.
Media
8. Place the media between the Media Guides, adjust the Media Guides
to the media width, and tighten the Locking Screw.
9. Check that the media path through the printer is straight. The media
should be centred under the Print Head.
Media Guide
Locking Screw
E2- 6
ENGLISH VERSION EO1-33089
Supply Holder
Guide Shaft
Supply Shaft
In the case of a label rolled with
the print side facing outside.
Guide Shaft
Print Head
Media
2.3 Loading Supplies
Projection
Groove
Locking Ring
Supply Holder
Media Guide