Toshiba B-EX4T1 Series Owner's Manual page 31

2. PRINTER SETUP
2.6.2 Parameter Setting
(Cont.)
2.6.2.1 Printer Set
(1) MEDIA LOAD
This parameter is to choose how the printer behaves to detect the
home position.
• OFF
• STD
• ECO
• ECO+Bfeed
(2) FORWARD WAIT
This parameter is to choose whether or not to activate the auto forward
wait function. This function, used in the cut mode, automatically
feeds the media forward if there is more than 1-second idle time after
printing, to prevent the top edge of the media from curling.
• OFF
• ON
(3) FORWARD WAIT POS.
When the auto forward feed wait parameter is set to ON, the feed
amount can be fine adjusted.
+5.0mm
+4.9mm
-4.9mm
-5.0mm
(4) FW/BK ACT.
• MODE1
The printer waits for next issue with 13.7-mm media
forwarded.
• MODE2
When the thermal transfer method, Transmissive
sensor, and cut issue are selected, the printer feeds 6-
mm media backward, then waits for next issue with
3-mm media forwarded.
.
E2-17
Media loading function is disabled (Same as a feed
by [FEED] key)
When the printer is tuned on, reset in batch, or print
head is closed, the printer detects a gap/black mark
and feeds the paper from the sensor to the print start
position.
When the printer is tuned on, reset in batch, or print
head is closed, the printer detects a gap/black mark
and feeds the paper to the print start position based
on the label pitch.
Economy + backfeed
Disables the auto forward feed wait
Enables the auto forward feed wait
ENGLISH VERSION EO1-33089
2.6 Printer Setting