Toshiba B-EX4T1 Series Owner's Manual page 35

2. PRINTER SETUP
2.6.2 Parameter Setting
(Cont.)
NOTE:
Since a detected remaining
ribbon length has some margin of
error, use the specified length as
a guide.
NOTE:
The type specified by the
command may differ from the
actual mode, depending on the
status of this parameter. Also,
the data transmission method
differs partly.
For details, refer to the External
Equipment Interface
Specification.
(11) WEB PRINTER
This parameter is to choose whether to use the printer as a web printer.
When the web printer is enabled, the status of the printer connected to
a network can be monitored through the web browser.
• OFF
• ON INTERNAL
• ON EXTERNAL
(12) RBN NEAR END
This parameter is to choose the remaining ribbon length where the
ribbon near end is detected.
• OFF
Ribbon near end is not detected.
• 30m
Ribbon near end is detected when the remaining
ribbon is 30-m long. (Equivalent to ribbon diameter
of 38 mm)
• 70m
Ribbon near end is detected when the remaining
ribbon is 70-m long. (Equivalent to ribbon diameter
of 43 mm)
(13) EX.I/O
This parameter is to choose a type of the expansion I/O interface
operating mode. This parameter needs to be set depending on the
expansion I/O control specification of the device to be connected via
the expansion I/O interface.
• TYPE1
Standard mode
• TYPE2
In-line mode
(14) LBL/RBN END
This parameter is to choose a printer processing when a label end or
ribbon end is detected.
• TYPE1
When a label/ribbon end is detected in the middle of
printing, the printer immediately stops printing.
• TYPE2
Selectable only when the ribbon saving function is
not activated.
When a label/ribbon end is detected in the middle of
printing, the printer prints the half-finished label as
far as possible, and stops when the next label is at the
home position.
(15) MAXI CODE
This parameter is to choose a Maxicode specification.
• TYPE1
Compatible with the current version
• TYPE2
Special specification
E2-21
ENGLISH VERSION EO1-33089
Disables web printer function
Enables web printer function (using an internal
memory)
Enables web printer function (using an external
memory)
2.6 Printer Setting