Toshiba B-EX4T1 Series Owner's Manual page 22

2. PRINTER SETUP
2.3.1 Loading the Media
(Cont.)
NOTES:
1. Be sure to set the Selection
Switch to STANDARD/
PEEL OFF position.
2. The backing paper is easier
to feed back to the Take-Up
Spool if the Front Plate is
removed.
3. Fit the Take-Up Clip so that
the longer side of the clip is
fitted into the shallow groove
in the Take-Up Spool.
4. The backing paper can be
wound directly onto the
Take-up Spool or a paper
core.
12. Batch mode
In the batch mode, the media is continuously printed and fed until
the number of labels/tags specified in the issue command have been
printed.
13. Loading with peel off module
When the optional Strip Module is fitted, the backing paper is
automatically removed from the label at the Strip Plate as each label
is printed.
(1) Remove enough labels from the leading edge of the media to leave
500mm of backing paper free.
(2) Insert the backing paper under the Strip Plate.
(3) Wind the backing paper onto the Take-up Spool and fix it in position
with the Take-up Clip. (Wind the paper counterclockwise around
the spool as this is the direction it rotates.)
(4) Rotate the Take-up Spool counter-clockwise a few times to remove
any slack in the backing paper.
(5) Set the Selection Switch mounted on the Rewinder Assembly to
STANDARD/PEEL OFF position.
Strip Plate Backing Paper
E2- 8
ENGLISH VERSION EO1-33089
2.3 Loading Supplies
Take-up Spool
Take-up Clip