Appendix 1 Messages And Leds - Toshiba SX4T - TEC B B/W Direct Thermal Owner's Manual

APPENDIX 1 MESSAGES AND LEDS

APPENDIX 1 MESSAGES AND LEDS
Appendix 1 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated.
2: ****: the number of unprinted media. Up to 9999 (in pieces)
3: %%%%%%%: ATA Card's remaining memory 0 to 9999999 (in K bytes)
4: ###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)
5: &&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)
LCD Message
No.
ON LINE
1
ON LINE
2
HEAD OPEN
3
PAUSE ****
4
COMMS ERROR
5
PAPER JAM ****
6
CUTTER ERROR****
7
NO PAPER ****
8
NO RIBBON ****
9 HEAD OPEN ****
10
HEAD ERROR
11
EXCESS HEAD TEMP
12
RIBBON ERROR****
13
REWIND FULL ****
SAVING%%%%%%%
14
or
SAVING ###&&&&
15
FLASH WRITE ERR.
16
FORMAT ERROR
17
FLASH CARD FULL
Display of error
18
message (See Notes.)
19
POWER FAILURE
20
INTIALIZING...
21
EEPROM ERROR
: The LED is flashing.
LED Indication
POWER ONLINE ERROR
In online mode
In online mode (The printer in
communication)
The print head block is opened in online
mode.
The printer is paused.
A parity, overrun, or framing error has
occurred during communication through
the RS-232C.
The media is jammed during paper feed.
A problem has occurred with the cutter
module.
The media has run out, or the media is
not loaded properly.
The ribbon has run out.
Feed or printing was attempted with the
print head block open.
There is a problem with the print head.
The print head is overheated.
The ribbon has been torn. A problem
has occurred with the sensor that
determines the torque for the ribbon
motor.
An overflow error has occurred in the
rewinder unit.
In writable character or PC command
save mode
An error has occurred while writing to
flash memory or ATA card.
An
formatting the flash memory or ATA
card.
Data cannot be stored because the flash
memory or ATA card is full.
A command error has occurred in
analyzing the command.
A power failure has occurred.
A flash memory card is being initialised.
Data cannot be read from/written to a
backup EEPROM properly.
EA1- 1
: The LED is unlit.
Printer Status
erase error has occurred
ENGLISH VERSION EO1-33058
APPENDIX 1 MESSAGES AND LEDS
Acceptance of
Restoration by
Status Request
RESTART key
Reset Command
Yes/No
-----
-----
-----
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
-----
No
in No
No
Yes
No
-----
-----
Yes/No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
-----
-----