Loading The Media - Toshiba B-EX4T1 Series Owner's Manual

2. PRINTER SETUP

2.3.1 Loading the Media

NOTES:
1. When the Head Lever is
turned to FREE position, the
Print Head is raised.
2. To enable printing the Head
Lever must be set to the
LABEL / TAG position.
(This ensures that the Print
Head is closed.)
There are two head pressure
levels in the LABEL / TAG
position. Set the Head Lever
depending on the media type:
Position LABEL: Labels
Position TAG : Tags
However, proper position
may differ depending on
media. For details, refer to
your TOSHIBA TEC
authorised service
representative.
3. Do not turn the Locking Ring
counter-clockwise too far or it
may come off the Supply
Holder.
The following procedure shows the steps to properly load the media into
the printer so that it feeds straight and true through the printer.
The printer prints both labels and tags.
1. Turn off the power and open the Top Cover.
2. Turn the Head Lever to FREE position, then release the Ribbon Shaft
Holder Plate.
3. Open the Print Head Block.
Print Head Block
FREE
LABEL
TAG
4. Turn the Locking Ring counterclockwise and remove the Supply
Holder from the Supply Shaft.
5. Put the media on the Supply Shaft.
6. Pass the media around the Guide Shaft, then pull the media towards
the front of the printer.
E2- 5
ENGLISH VERSION EO1-33089
2.3 Loading Supplies
Top Cover
Head
Lever
Ribbon Shaft Holder Plate
Locking Ring
Supply Shaft
Supply Holder