Fujitsu SPARC ENTERPRISE M3000 Xscf Reference Manual page 534

testsb(8)
OPTIONS
OPERANDS
EXTENDED
DESCRIPTION
510 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
The following options are supported:.
-c {all|expansion} Specifies the target PSB to be diagnosed. One of the values
-h
-m diag=mode
-n
-q
-v
-y
The following operand is supported:
location Specifies only one PSB number. An integer from 00–15 can be
specified.
When the command is executed, a prompt to confirm execution of the command
■
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
When the system board (XSB) belonging to the specified PSB is in any status
■
below, the testsb(8) command results in an error.
XSB is installed in the domain and this domain is in operation.
■
shown below can be specified:
Diagnoses all the PSB that are mounted.
all
If the following conditions not satisfied, it leads to an error.
The system has been powered off.
■
All of the target PSB are Uni-XSB.
■
Diagnoses all the PSB that are mounted
expansion
on the expansion cabinet.
If the following conditions not satisfied, it leads to an error.
All of the target PSB are not operating on the domain.
■
All of the target PSB are Uni-XSB.
■
Displays usage statement. When used with other options or
operands, an error occurs.
Specifies the diagnostic level of initial diagnosis. One of the
values shown below can be specified:
Normal (default)
min
Maximum
max
Automatically answers "n" (no) to all prompts.
Suppresses all messages to stdout, including prompts.
Displays a detailed message of initial diagnosis.
Automatically answers "y" (yes) to all prompts.