setdomainmode(8)
EXAMPLES
190
SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
The settings of the current modes of operation for the specified domain can be
■
checked by using the showdomainmode(8) command. When you use the
showdomainmode(8) command after the setdomainmode(8) command, it will
display the pending modifications performed by the setdomainmode(8), which
might not yet be effective.
Sets the OpenBoot PROM diagnostic level for domain ID 0 to none.
EXAMPLE 1
setdomainmode -d 0 -m diag=none
XSCF>
Diagnostic Level
Secure Mode
Autoboot
CPU Mode
The specified modes will be changed.
y
Continue? [y|n]:
configured.
Diagnostic Level
Secure Mode
Autoboot
CPU Mode
Enables the auto boot function for domain ID 0. Automatically answers
EXAMPLE 2
all prompts.
setdomainmode -y -d 0 -m autoboot=on
XSCF>
Diagnostic Level
Secure Mode
Autoboot
CPU Mode
The specified modes will be changed.
y
Continue? [y|n]:
configured.
Diagnostic Level
Secure Mode
Autoboot
CPU Mode
:min
-> none
:on
-> -
:on
-> -
:auto
-> -
:none
:on (host watchdog: available Break-signal:non-receive)
:on (autoboot:on)
:auto
:none
-> -
:on
-> -
:off
-> on
:auto
-> -
:none
:on (host watchdog: available Break-signal:non-receive)
:on (autoboot:on)
:auto
"
"
to
y