Fujitsu SPARC ENTERPRISE M3000 Xscf Reference Manual page 248
Xscf control package (xcp) 109x
Hide thumbs
Also See for SPARC ENTERPRISE M3000:
- Xscf reference manual (542 pages) ,
- Service manual (202 pages) ,
- Product notes (144 pages)
Table of Contents
Advertisement
setldapssl(8)
224
SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised February 2010
logdetail
log [options] clear
strictcertmode
Enable logging of LDAP/SSL authentication and
authorization diagnostic messages at the specified detail
level. This log is for use in troubleshooting and is cleared
on SP reboot. Level can be one of the following:
none
Do not log diagnostic messages. Use
this setting during normal system
operation
high
Log only high-severity diagnostic
messages
medium
Log only high-severity and medium-
severity diagnostic messages
low
Log high-severity, medium-severity,
and informational diagnostic
messages
trace
Log high-severity, medium-severity,
informational, and trace-level
diagnostic messages
Clear the log file of LDAP/SSL authentication and
authorization diagnostic messages.
Enable or disable strictcertmode mode. This mode is
disabled by default; the channel is secure, but limited
validation of the certificate is performed. If strictcertmode
is enabled, the server's certificate must have already been
uploaded to the server so that the certificate signatures
can be validated when the server certificate is presented.
Data is always protected, even if strictcertmode is
disabled. Strictcertmode applies to primary and alternate
servers alike.
Advertisement
Table of Contents
