Fujitsu SPARC ENTERPRISE M3000 Xscf Reference Manual page 152

reset(8)
OPERANDS
EXTENDED
DESCRIPTION
EXAMPLES
128 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised August 2009
The following operand is supported:
level Specifies the level of resetting. One of the following can be
specified. This operand cannot be omitted.
por
panic
xir
When the command is executed, a prompt to confirm execution of the command
■
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
The showdomainstatus(8) command can be used to check whether the domain
■
has been reset.
If the reset(8) command is executed under either of the following conditions,
■
processing is stopped before the Solaris OS is started:
The Mode switch on the operator panel is set to Service mode
■
The auto boot function has been disabled by the setdomainmode (8)
■
command
Causes a panic in domain ID 0.
EXAMPLE 1
reset -d 0 panic
XSCF>
DomainID to panic:00
y
Continue? [y|n]:
00:Panicked
*Note*
This command only issues the instruction to reset.
The result of the instruction can be checked by the "showlogs power".
Resets the CPU in domain ID 0. Automatically answers
EXAMPLE 2
reset -y -d 0 xir
XSCF>
DomainID to reset:00
y
Continue? [y|n]:
00:Reset
Resets the domain system.
Instructs the Solaris OS of the domain to
generate a panic.
Resets the domain CPU.
" "
to all prompts.
y