Fujitsu SPARC ENTERPRISE M3000 Xscf Reference Manual page 472

shownetwork(8)
OPERANDS
EXTENDED
DESCRIPTION
448 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised February 2010
The following operands are supported:
interface Specifies the network interface whose information is to be
displayed. One of the following values can be specified,
depending on the system configuration. If this operand is
specified with the -a option, the operand is ignored.
■
For XSCF unit 0 :
xscf#0-lan#0
xscf#0-lan#1
For abbreviation:
lan#0
lan#1
■
For XSCF unit 0 :
xscf#0-lan#0
xscf#0-lan#1
xscf#0-if
For XSCF unit 1:
xscf#1-lan#0
xscf#1-lan#1
xscf#1-if
For takeover IP address:
lan#0
lan#1
In the M8000/M9000 servers, a takeover IP address can be used without a need
■
to determine whether XSCF has been switched. By setting the LAN ports of the
active XSCF unit as lan#0 and lan#1, they can be accessed with the names
lan#0 and lan#1.
In the M3000/M4000/M5000 servers, the value of the lan#0 is fixed with
■
xscf#0-lan#0, and the lan#1 is fixed with xscf#0-lan#1.
In the M3000/M4000/M5000 servers:
XSCF-LAN#0
XSCF-LAN#1
an abbreviation of XSCF-LAN#0
an abbreviation of XSCF-LAN#1
In the M8000/M9000 servers:
XSCF-LAN#0
XSCF-LAN#1
Interface between XSCF units (Inter SCF
Network; ISN)
XSCF-LAN#0
XSCF-LAN#1
ISN
takeover IP address for XSCF-LAN#0
takeover IP address for XSCF-LAN#1