Setlocator - Fujitsu SPARC ENTERPRISE M3000 Xscf Reference Manual

NAME setlocator - control the blinking of the CHECK LED on the operator panel
SYNOPSIS setlocator value
setlocator -h
DESCRIPTION setlocator(8) command controls the blink state of the CHECK LED on the
operator panel.
The following states can be set:
Start blinking
Stop blinking
Privileges You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following option is supported:
-h
OPERANDS The following operand is supported:
value
EXTENDED The showlocator(8) command can be used to check the CHECK LED state.
DESCRIPTION
EXAMPLES
EXAMPLE 1
EXAMPLE 2
Makes the CHECK LED blink.
Stops the blinking of the CHECK LED.
Displays usage statement. When used with other options or
operands, an error occurs.
Specifies the CHECK LED state. One of the following can be
specified:
blink
reset
Starts the CHECK LED blinking.
setlocator blink
XSCF>
Stops the CHECK LED blinking.
setlocator reset
XSCF>
Starts the CHECK LED blinking.
Stops the CHECK LED blinking.
System Administration

setlocator(8)

231