Fujitsu SPARC ENTERPRISE M3000 Xscf Reference Manual page 125

OPERANDS The following operand is supported:
xsb
EXTENDED
■
DESCRIPTION
■
■
■
■
■
Specifies the XSB number to be moved. Multiple xsb operands are
permitted, separated by spaces. The following xsb form is
accepted:
x–y
where:
x
y
You can execute the moveboard(8) command on a source domain or a
destination domain that is not running. When the source domain is running, the
moveboard(8) command with "-c configure" or "-c assign" will succeed
only if the following Solaris Service Management Facility (SMF) services are
active on that domain:
Domain SP Communication Protocol (dscp)
■
Domain Configuration Server (dcs)
■
Sun Cryptographic Key Management Daemon (sckmd)
■
When the command is executed, a prompt to confirm execution of the command
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
If "-c configure" is specified when either of the following conditions apply to
the domains, the XSB is configured in the domain configuration:
The Solaris OS of both the source and destination domains are running.
■
The Solaris OS of the destination domain is running even though the source
■
domain is powered off.
If "-c assign" is specified when either of the following conditions apply to the
domains, the XSB is assigned to the domain configuration:
The Solaris OS of the source domain is running.
■
The source domain is powered off
■
If "-c reserve" is specified when either the domain power of the move source
has been turned off or the Solaris OS is not running, the XSB is immediately
disconnected from the domain of the move source and assigned to the domain of
the move destination
Moving the XSB involves the following internal operations and therefore
command execution may take time.
Disconnecting the hardware resource of the XSB from the Solaris OS
■
Running a hardware diagnosis on the XSB when connecting it
■
An integer from 00–15.
An integer from 0–3.
System Administration
moveboard(8)
101