Table of Contents
Advertisement
Using the Agilent E6176A 16-Channel Load Card
E6198B Switch/Load Unit User Manual
A block diagram of the Agilent E6176A 16-Channel
High-Current Load Card is shown in
layout is shown in
Figure
load density for high-current loads where current transducers
and bridge drive configurations are not required.
• The card is one slot wide.
• The card type is 02
• The factory default configuration is explained in
Power Supply
Configuration".
• The factory default is to load a 0.05 , 0.1% Isense resistor in
each channel.
"Selecting a Current-Sense Resistor Value"
• The flyback protection is connected from both the normally
open (NO) and normally closed (NC) power switch
connections.
"Selecting and Loading Flyback Protection"
• Loads are mounted externally and interface to the card using
two load connectors, J1 and J2.
Using Load Cards and Loads
Figure
5-18. The single-slot design offers high
"Card Location Recommendations"
.
"Load Card Type and Configuration ID"
h
"Connecting Loads"
5
5-17. The load card
"Selecting a
5-25
Advertisement
Table of Contents
