Figure 5-7 Wiring Options Of Lem Model La25-Np Primary For Various Current Ranges; Table 5-2 Components Involved In Lem Module Installation - Agilent Technologies E6198B User Manual

Table 5-2 Components involved in LEM Module Installation

Channel(s) Isense
Resistor
(Rmvd)
1, 2 R1
3, 4 R3
5, 6 R5
7, 8 R7
* This load card was tested with a LEM Model LA25-NP Current Transducer from LEM USA, Inc. 6643 West
Mill Road, Milwaukee, WI, 53218. (414) 353-0711
E6198B Switch/Load Unit User Manual
Figure 5-7 Wiring Options of LEM Model LA25-NP Primary for Various
Current Ranges
Table 5-2 details the components that need to be
installed/replaced for each of the two channel pairs of the
Agilent E6175A 8-Channel Load Card.
Measuring Shorting
Resistor Jumper
R2 TP41 to
TP42
R4 TP43 to
TP44
R6 TP45 to
TP46
R8 TP47 to
TP48
The board was tested with a LEM Model LA25-NP
information about the use of this current transducer is available
from the manufacturer.
Using Load Cards and Loads
Bypass LEM
Capacitors Module
(0.01 f)
C41 and C42 U1
C43 and C44 U2
C45 and C46 U3
C47 and C48 U4
5
LEM Tap
Connection
See LEM module
Spec. Sheet
See LEM module
Spec. Sheet
See LEM module
Spec. Sheet
See LEM module
Spec. Sheet
*
. Additional
5-13