Adding A Second Switch/Load Unit; Figure 4-14 Frame Select Interface (Standalone Slu) - Agilent Technologies E6198B User Manual

Adding a Second Switch/Load Unit

E6198B Switch/Load Unit User Manual
You can add a second Switch/Load Unit to the system as the
load and switching requirements increase. Connection to the PC
controller can be made to any existing USB port or via an
externally powered USB hub.
For Standalone SLU, the Frame Select toggle switches, sets the
address of each Switch/Load Unit (see
switches can be set for any address from zero to seven.
However, for the Integrated SLU, jumpers must be used for
frame select.(See Figure
Switch/Load Units can have the same address. The factory
default position is Address 0. As an example, you can leave the
address of the first Switch/Load Unit set to 0 and set the
address of the second Switch/Load Unit to 1.

Figure 4-14 Frame Select Interface (Standalone SLU)

Configuring the Switch/Load Unit
Figure
4-10). For each system, no two
4
4-14). The toggle
4-13