Table of Contents
Advertisement
5
Using Load Cards and Loads
UUT Connections
When configured as part of a standard Agilent system, P2 of the
load card is typically connected via cables to a mass
interconnect panel. User connections to the UUT are then made
from the mass interconnect panel. Refer to the appropriate
mass interconnect wiring guide for connection details.
You can also make connections directly to P2.
Figure 5-32
is a
P2 connector pinout showing the details.
Figure 5-32 Agilent E6177A 24-Channel Medium-Current Load Card UUT Connections
E16
E1
E6198B Switch/Load Unit User Manual
5-45
Advertisement
Table of Contents
