Miscellaneous Commands - Microcom 324M Operator's Manual

Chapter 5
7. Send 'g f0000' to the printer.
8. Send 'n 512074459' to the printer.
9. Send 'z' to the printer.
10. Wait for the 'Boot loader updated!' message dialog to be reported.
11. Send 'xa' to the printer.
12. Wait for the 'Sector(s) Erased.' Message dialog to be reported.
13. Send the MCA or application file to the printer.
14. Wait for the 'Device programmed successfully' message dialog to be reported.
15. Send 'g90000' to the printer.
16. Send the '^A21481^D7 command to the printer.
17. Send the MCE or embedded fonts file to the printer.
18. Wait for the 'File download successful' message dialog to be reported.
19. Wait for the 'Factory default font ready,' message dialog to be reported.
20. Issue a '^D29' command to the printer and verify that the code version has been
updated.
5.15

Miscellaneous Commands

^A ^D Command
93 Load Control Code Recognition Status:
0 Enable control code recognition
1 Disable control code recognition
113 Verbose Mode:
0 Disable Verbose Mode
1 Enable Verbose Mode
X 145 List Commands.
This command is used to generate a list of commands containing a brief
description of the LDSI code base that the printer uses.
0 Show all commands.
1 Show current volatile settings.
2 Show current soft switch settings in plain English.
324M/424M Operator's Manual - 880026-1001
Printer Commands
5-45