Miscellaneous Commands - Microcom 424 Operator's Manual

Chapter 5
^A ^D COMMAND
140 Clear all User GRAPHIC and FONT FLASH.
This command erases the user FONTS and GRAPHICS in FLASH memory.
This command is equivalent to sending:
1) ^A0^D134 (clears all GRAPHICS),
2) ^A0^D137 (clears all FONTS).
Label FORMATS stored in user FLASH memory are NOT erased by this
command. Use the ^D131 command to erase label FORMATS stored in
FLASH memory.
IMPORTANT NOTE!!! Embedded FONTS and label FORMATS are NOT
erased. However, any custom FONTS and GRAPHICS loaded into user
FLASH memory at the factory WILL be erased. Please contact Microcom
Corporation if you have any doubts about custom GRAPHICS and/or FONTS
that may be stored in FLASH memory.
Hint: After the user FLASH has been deleted, the ^D119 command may be used to
verify that Slots #1 thru #255 are now available in FLASH.
141 Clear User GRAPHIC and FONT FLASH & RAM memory.
This command clears all user FONTS and GRAPHICS in FLASH memory, and
all the downloaded FONTS and GRAPHICS in RAM. This command is the
equivalent to sending:
1) ^D100 (clears all downloaded FORMATS, FONTS and GRAPHICS
2) ^A0^D140 (clears all user FONTS and GRAPHICS in FLASH).
Label FORMATS stored in user FLASH memory are NOT erased by this
command. Use the ^D131 command to erase label FORMATS stored in
FLASH memory.
Please note that this command may take some time (depending on how much
is stored). During this time the printer will not respond to commands. The
printer may appear to be locked up until the command finishes.
Hint: Use command ^D119 to confirm that FONTS and GRAPHICS were erased in
user FLASH memory, and that all downloaded FORMATS, FONTS, and
GRAPHICS were erased in RAM.

5.17 Miscellaneous Commands

^A ^D Command
93 Load Control Code Recognition Status:
0 Enable control code recognition
1 Disable control code recognition
224/424 Operator's Manual - 880027-1000
in RAM,
Printer Commands
5-41