Microcom 324M Operator's Manual page 185

^A ^D Command
1 143 Restart Printer (Soft Restart): This command instructs the printer to save
statistics stored in RAM to non-volatile flash memory and then actually resets
the printer hardware. Issuing this command is the equivalent of turning the
printer OFF and ON. This command may be used to start using certain non-
volatile system parameters (print head parameter and soft switch commands).
X 145 List Commands.
This command is used to generate a list of commands containing a brief
description of the LDSI code base that the printer uses.
0 Show all commands.
1 Show current volatile settings.
2 Show current soft switch settings in plain English.
146 Pre-Stock-Out Distance:
This command sets the distance in dots that the PSO option uses to feed the
media when the >INPUT 1< sensor detects an out-of-media condition. If the
length of the label happens to be larger than the distance from the Pre-Stock-
Out sensor to the dot row (^D146 command) the printer will not be able to
completely finish printing the last label.
147 Auto-Header Command:
0 Execute Auto-Header on power up only.
1 Execute Auto-Header on the next media loading.
2 Execute Auto-Header immediately (after delay, assumes that media is loaded.
3 Execute Auto-Header every time media is loaded.
148 Show Auto-Header Values Command:
After the Auto-Header has been executed, the values that the printer will use
for the header may be seen using the command ^D148.
150 Report Status of GP Inputs.
This command is used to report the current status of the GP inputs. This is
only used with the General Purpose I/O Hardware Mode. When issued, the
printer will send the host the current status of the 4 general inputs in the form
of ">IO 0nH< where "n" is a hex number from 0 to F.
X 151 Fatal General Purpose Input.
This command determines which general purpose inputs are configured to
cause an immediate error when active. The ^Ax specifies which inputs will
cause the error, with the x being a hex number 0 to F.
X 153 Dot Feed Forward.
Feeds the media forward at the given speed. The ^Ax is the number of dots to
move.
13-16 324M/424M Operator's Manual - 880026-1001