Cutter Configuration Commands; Cutter Type; Kiosk Cutter Commands; Kiosk Cutter Mode - Microcom 324M Operator's Manual

Printer Commands
The following is an example of the ^D61, ^D63, and ^D64 commands:
^A0^D64<CR>
^D57<CR>
6,1280,900,,38,7,0,1,385,0,0 <CR>
1,300,300,20,1,4<CR>
2,300,250,20,1,4<CR>
3,300,200,20,1,4<CR>
4,300,150,20,1,4<CR>
5,300,100,20,1,4<CR>
6,300,50,20,1,4<CR>
^D56 <CR>
^D2 <CR>
Protected Field<CR>
Protected Field<CR>
Protected Field<CR>
Variable Field<CR>
Variable Field<CR>
Variable Field<CR>
^A3^D63<CR>
^A3^D64<CR>
^A4^D61<CR>

5.10 Cutter Configuration Commands

5.10.1

Cutter Type

The ^D115 is a non-volatile command that sets the proper type of cutter installed on the
printer being used. This value is reported to the ^D29 statistics label. This command
should be used prior to enabling the cutter with the ^D99 or ^D111 commands.
^A ^D Command
X 115 Set Cutter Type:
0 No Cutter
1 Guillotine
2 Rotary
5.10.2

Kiosk Cutter Commands

5.10.2.1

Kiosk Cutter Mode

This is a non-volatile command that enables cutter operation. When a printer is configured
to use the ^D111, the printer prints a job, dispenses the advance distance (See ^D112), and
then cuts the media. The media is not retracted until the next format, which helps to prevent
paper jams going into the cuter or media wrapping around the platen roller.
5-34
(Clears any old settings)
(Enables Auto-Print and Clears text)
(Instructs printer to print after 3 <CR>)
(Instructs printer to start text entry at line 4
instead of line 1)
324M/424M Operator's Manual - 880026-1001
Chapter 5