Microcom 324M Operator's Manual page 175

^A ^D Command
26 Software Switch #6: A non-volatile command used to set the various
functions identified below.
^AB12345678
*******.))) Always 0
******.)))) 1 = Enable Cutter PIC Mode of Operation
******
*****.))))) 1 = Enable Custom I/O Hardware
*****
****.)))))) 1 = Enable 48-466 Emulation Mode
****
***.))))))) 1 = Enable >STOCK NOT LOADED<; 0 = Disable
**.)))))))) 1 = Enable Pre-Stock-Out Feature; 0 = Disable
*.))))))))) 1 = Enable Auto-Header; 0 = Disable Auto-Header
.)))))))))) 1 = Enable >TRAY FULL< condition
X 29 Printer Statistics:
0 Print Statistics to the serial port.
1 Print Statistics on a label.
2 Clear the Printed Labels variable in the statistics.
3 Clear the Printed Inches variable in the statistics.
32 Reset Printer: Restores the printer to power-up settings. Also used to set the
non-volatile fields in memory.
33 Display Model and Revision Number
XX 35 Adjust Contrast Window: This is the temporary contrast adjustment. The
^Axx range is from 60% to 140%.
XX 36 Adjust Contrast Base: This is a non-volatile command that adjusts the
contrast base value. The ^Axx specifies a value from 10% to 200%.
X 39 Auto-Size Label:
0 Clears the auto-size values determined by the ^A1^D39 command.
1 Uses values obtained for the variables instead of what the user supplies in the
header of the format file.
2 Automatically sizes the label and displays on the screen the values for the
header variables.
3 Same as ^A2^D39, but prints the values on a label, instead of on the screen.
5 Diagnostic Mode (Tick-Tick)
40 Clears Commands 41 through 51
XX 41 Load Number of Fields in Layout (HFM): The ^Axx specifies the value.
XX 42 Load Label Width in dots (LXS): The ^Axx specifies the value.
13-6
0 = Enable Take-Up PIC Mode of Operation
0 = Enable General Purpose I/O Hardware
0 = Disable 48-466 Emulation Mode
0 = A test pattern is printed
324M/424M Operator's Manual - 880026-1001