Microcom 324M Operator's Manual page 93

Chapter 5
Hint: After the FONT file has been deleted, the ^D119 command may be used to
verify that Slot #xx is now available in FLASH. The FONT may extend over
several slots and the ^D119 will indicate how many slots are used.
^A ^D COMMAND
XX 138 Process a FLASH FORMAT.
^Axx references the FORMAT file stored in Slot #xx
Valid values for Axx are 1to 128.
Label FORMATS are saved into FLASH Slots #1 thru #128. Each of these
FORMAT slots specifies how to build the dot rows that are used to print a label
on the 324M and 424M printers.
This command tells the printer to take the Label FORMAT file in Slot #xx and
build up its image in the printer's slice buffer. After this command is finished,
the label may be printed by sending the ^C print command (See 5.1).
NOTE: If the FORMAT file contains a print command, then the label will be
printed at the end of this command.
XX 139 Send a FLASH FORMAT to the Host.
^Axx references the FORMAT file stored in Slot #xx
Valid values for Axx are A1 to A128.
Label FORMATS are saved into FLASH Slots 1 to 128. This command
causes the printer to send a previously loaded FORMAT file out the
communications port to the HOST.
Use this command to view label FORMATs that have been saved in the
printer's non-volatile FLASH memory.
140 Clear all User GRAPHIC and FONT FLASH.
This command erases the user FONTS and GRAPHICS in FLASH memory.
This command is equivalent to sending:
Label FORMATS stored in user FLASH memory are NOT erased by this
command. Use the ^D131 command to erase label FORMATS stored in
FLASH memory.
IMPORTANT NOTE!!! Embedded FONTS and label FORMATS are NOT
erased. However, any custom FONTS and GRAPHICS loaded into user
FLASH memory at the factory WILL be erased. Please contact Microcom
Corporation if you have any doubts about custom GRAPHICS and/or
FONTS that may be stored in FLASH memory.
Hint: After the user FLASH has been deleted, the ^D119 command may be used to
verify that Slots #1 thru #255 are now available in FLASH.
324M/424M Operator's Manual - 880026-1001
1. ^A0^D134 (clears all GRAPHICS),
2. ^A0^D137 (clears all FONTS).
Printer Commands
5-43