Microcom 324M Operator's Manual page 177

^A ^D Command
X 63 Text Control Mode: Allows the entry of new text without the ^D2 command
and/or clears all previous text when new text is added.
0 Disable 1 and 2
1 Enable Auto-Print Mode
2 Clear all previous text upon receiving new data.
3 Enable 1 and 2
XX 64 Auto-Print String Count: The ^Axx instructs the printer how many text strings
to accept before printing.
XX 66 Clear Single FORMAT Stored in RAM: The ^Axx specifies which memory
slot to clear (1-128). This command only functions with FORMAT files and not
with downloadable fonts and/or graphics.
68 Set GP Output to Active: This command specifies which of the GP outputs
are active. The command syntax is ^D68<CR>0n<CR>, where n is a hex
value that is equal to a binary number with the outputs in the following order;
4321.
69 Report Status of GP Outputs: This command is used to read and report the
current status of the GP Outputs in the form of ">IO 0nH< where "n" is a hex
number from 0 to F. The outputs equal a binary number with the values in the
following order; 4321.
70 Clear Commands 73 through 76
71 Load MaxiCode Bar Code Data
XX 73 Load Copies Count: Instructs the printer to print a group of labels. This
command will not increment/decrement serial numbers.
X 74 Infinity Print: Continues to print copies of a format until the power is shut off.
The valid ^Ax values are "1" to enable and "0" to disable this command.
XX 75 Load Label Count: Instructs the printer to print a batch of labels using the
serial number functions if enabled.
XX 76 Load Delay Time Between Labels: The ^Axx specifies the delay time in
1/10ths of a second. Maximum value is 650.
77 Load PDF-417 Bar Code Data
XX 78 Set Print head # of Dots: The ^Axx specifies the number of dots available in
the print head. Valid values are A448, A640, A832, A960, and A1280.
XX 79 Set Print head Dot Density: The ^Axx specifies the number of dots/inch
available in the print head. Valid values are A0 and A1.
13-8 324M/424M Operator's Manual - 880026-1001