Peripheral Bay Device - Intergraph Zx10 5U System Manual

To replace the system disk drive:
WARNING The system is always on when connected to AC power. Before performing this
task, disconnect the system's power cord from its AC power outlet.
WARNING Mishandling a removed disk drive can cause the heads to crash! Subsequent
failures may not be noticeable for three to six months. Handle disk drives
carefully to avoid damage.
1. Remove the top cover. See Chapter 7, "Gaining Access to System Components."
2. Disconnect the power cable and SCSI cable from the disk drive.
3. Remove the four nuts (two on each side) from the vertical screws on each side of the disk
drive, and lift the disk drive out of the base unit.
4. Remove the two disk brackets from the disk drive and secure them to the new disk drive.
5. Replace the new disk drive in the base unit and secure it with the four nuts removed
previously.
6. Connect the power cable and SCSI cable to the disk drive.
7. Replace the top cover. See Chapter 7, "Gaining Access to System Components."

Peripheral Bay Device

The CD-ROM drive, the floppy disk drive, and (optionally) another EIDE or SCSI device are
located in the peripheral device bay, below the system disk drive. You can remove and replace
any of these devices, and add a device if a bay is open, in the same way.
To add or replace a device in the peripheral device bay:
WARNING The system is always on when connected to AC power. Before performing this
task, disconnect the system's power cord from its AC power outlet.
WARNING The CD-ROM drive contains a laser and is classified as a Class 1 Laser
Product. To prevent direct exposure to the laser beam and to avoid hazardous
radiation exposure, do not try to open the CD-ROM drive enclosure. Return the
drive to the manufacturer for repair.
WARNING Mishandling a disk drive can cause the heads to crash! Subsequent failures
may not be noticeable for three to six months. Handle disk drives carefully to
avoid damage.
1. Remove the top cover and open the front panel. See Chapter 7, "Gaining Access to System
Components."
2. For ease of access, remove the rear fan. See "Cooling Fans" in this chapter.
3. If removing or replacing the floppy disk drive, remove the CD-ROM drive first.
4. Disconnect the power cable and data cables from the device.
59