Read Status Set Up Group; Table 20 Read Status Set Up Group Parameters - Honeywell HercuLine 2000 Series Installation, Operation And Maintenance Manual

Read Status Set Up Group

Table 20 lists the parameters and selections available for the READ STATUS group.
Actuator Lower
Display
Prompt
FAILSF
RAMTST
SEETST
CFGTST
CALTST
Revision 7 HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
7/08

Table 20 Read Status Set Up Group Parameters

Selections or
Range of Setting
FAILSAFE — Read Only. Shows whether actuator in
failsafe.
No — Actuator not in failsafe.
NO
YES
Yes— Actuator in failsafe, see
Troubleshooting (page 105)
RAM TEST DIAGNOSTIC — Read Only. Shows status of
RAM test diagnostic.
Pass — Test passed, no errors
PASS
FAIL
Fail— Test failed, see see
Troubleshooting (page 105)
SERIAL EEPROM TEST DIAGNOSTIC — Read Only.
Shows status of serial electrically eraseable PROM test
diagnostic.
Pass — Test passed, no errors
PASS
FAIL
Troubleshooting (page 105)
CONFIGURATION TEST DIAGNOSTIC — Read Only.
Shows status of Configuration test diagnostic.
Pass — Test passed, no errors
PASS
FAIL
Fail— Test failed, see
Troubleshooting (page 105)
CALIBRATION TEST DIAGNOSTIC — Read Only. Shows
status of Calibration test diagnostic.
Pass — Test passed, no errors
PASS
FAIL
Fail— Test failed, see
Troubleshooting (page 105)
Set Up and Calibration Procedures
Parameter Definition/PDA HercuLink
Fail— Test failed, see
Read Status Set Up Group
®
Prompt
55