Specifications; Technical And Operating Specifications; Table 1 Specifications - General - Honeywell HercuLine 2000 Series Installation, Operation And Maintenance Manual

This section provides you with the technical specifications and the model selection guide for the
®
HercuLine 2000 Series Actuators.

Technical and Operating Specifications

Weight
Enclosure
Gear Train
Mechanical Stops
Storage Temperature
Relative Humidity
Scale
Crank Arm
Output Shaft
Rotation
Manual Handwheel
Lubrication
Output Torque/Full
Travel Stroking Time
Revision 7 HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
7/08

Specifications

Table 1 Specifications - General

Physical
2000: 25 lb. (11.36 kg)
2001,2002: 27 lbs. (12.27 kg)
Precision-machined die cast aluminum housing, finished in light gray powder coat
epoxy.
Alloy steel, high efficiency steel spur gear primary train. Precision ground, self-
locking/self releasing worm gear final mesh.
Factory set at 90° or 150° (+/-5°).
Attention: Do not adjust the mechanical Stops. Adjusting the stops will void
the warranty
–40 °C to +93 °C (–40 °C to +200 °F)
0 % to 99 % R.H. non-condensing over the full operating temperature range.
0 % to 100 % corresponding to full crank arm travel.
Adjustable radii 1.0 in (25.4mm) to a maximum of 2.8 in (71.1mm). Position
adjustable through 360° rotation.
0.625+/-.005 in (15.88 +/-.13mm) diameter
90° or 150° degrees between 0 % and 100 % on scale, limited by mechanical stops.
Provides a means of positioning the actuator in the event of a power failure or set-
up.
Texaco Starplex 2 EP Grease
Torque lb-in (N
M)
50 / (6.0)
100 / (11.5)
200 / (22.5)
400 / (45.0)
400 / (45.0)
Technical and Operating Specifications
50 Hz (90°/150°)
4.5 / 7.5
9 / 15
18 / 30
36 / 60
54 / 90
Specifications
60 Hz (90°/150°)
4 / 6
7 / 12
15 / 25
30 / 50
45 / 75
5