Honeywell HercuLine 2000 Series Installation, Operation And Maintenance Manual page 68

Set Up and Calibration Procedures
Maintenance Set Up Group
Actuator Lower
Display
Prompt
DATSAV
PASSWRD
MANRST
60 HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
Selections or
PDA users: The prompts are organized differently on your PDA's
Range of Setting
software. Grayed prompts are under Configuration, Maintenance. Non-grayed
MAINTENANCE DATA FORCED SAVE — Allows you to
manually force a save of the current maintenance data
DIS
values.
ENAB
DISABLE — Forced data save is disabled.
ENABLE — Forced data save is enabled.
PASSWORD — If a password has been activated, then a 4-
nnnn
digit password is required to enable any of the functions
below.
NOTE: Password is set (or changed) from the Lock set up
group.
MAINTENANCE STATISTIC RESET — Allows reset of the
following maintenance statistics:
None — No reset of maintenance statisitics
NONE
Stall — Resets accumulated stall time to zero.
STAL
Motor Starts — Resets the accumulated motor start counter
STRT
to zero.
Motor Starts in the Region — Resets the selected motor
REGNn
n = 0 to 9 span region counter to zero.
Temperature Statistics — Resets the high / low
TEMP
temperature limit statistics.
Total Degrees — Resets the total degrees of motor travel to
TDEG
zero.
Relay Counts — Resets the selected accumulated relay
RELn
n = 1, 2, 3 or 4 cycle counter to zero.
All — Resets all maintenance statistics to zero.
ALL
SYST — Enables the system restart function.
SYST
default = NONE
Parameter Definition/PDA HercuLink
prompts are under Maintenance.
®
Prompt
HercuLink ®
Revision 7
7/08