Table of Contents
Advertisement
Using the Flash Utility
The Flash Utility is used to upgrade firmware, BIOS, boot block, and BIOS
Configuration Utility software by "flashing" the new code stored in an
identified .IMG file to the on-board BIOS of the Mylex PCI Disk Array
Controller. As maintenance releases of this code become available, this
utility allows you to keep your controller current using GAM.
Caution
If Expand Array (Expand Capacity) is running or was
stopped, you must allow the process to run to
completion BEFORE replacing controllers and
flashing new firmware. Otherwise, data corruption
may result!
Open the Flash Utility as shown in Figure 6-7:
Manual No. SA67-0049-01
Figure 6-7. Select "Flash Utility"
Maintenance Processes
6-7
Advertisement
Table of Contents
Need help?
Do you have a question about the Global Array Manager and is the answer not in the manual?
Questions and answers