Import (Import Hba Configuration) - Qlogic SANsurfer iSCSI HBA CLI User Manual

A
The following shows an example of how the HBA port information might appear:
0. HBA 0 Port: 0 HBA Port Instance: 0 HBA Model: QLA4050C
HBA Serial Number: FS20525B03135
IP Address: 192.168.3.7
Alias:
iSCSI name: iqn.2000-04.com.qlogic.fs10506a02810.1
1. HBA 1 Port: 0 HBA Port Instance: 1 HBA Model: QLA4062C
HBA Serial Number: AS40637A04673
IP Address: 192.168.3.22
Alias:
iSCSI name: iqn.2000-04.com.qlogic.as10506a02810.1
2. HBA 1 Port: 1 HBA Port Instance: 2 HBA Model: QLA4062C
HBA Serial Number: AS40637A04673
IP Address: 192.168.3.38
Alias:
iSCSI name: iqn.2000-04.com.qlogic.as10506a02810.1
3. HBA 2 Port: 0 HBA Port Instance: 3 HBA Model: QLA4010
HBA Serial Number: FS20407B03135
IP Address: 192.168.3.72
Alias:
iSCSI name: iqn.1991-05.com.microsoft.steinway.qlogic.org
For information on the interactive version of this command, see
iSCSI HBA Ports Detected (CLI Option -i)" on page
-import
(Import HBA Configuration)
To import an HBA configuration from a file (see
on page
-import <hba_no_target> <hba_no_Source> [A] [F N I T C B] <File
Name>
Where:
<hba_port_inst> = The specific HBA to which the data is written
SN0054621-00 E
5-28), enter the -import command as follows:
= The file with the HBA configuration you want.
<hba_port_inst_
source>
A = Configure all imported parameters (F, N, I, T, C, B).
F = Configure the firmware.
N = Configure the network parameters.
5 – Non-Interactive Mode Commands
Non-interactive Commands
FW Version: 2.2.4.45
FW Version: 3.0.1.18
FW Version: 3.0.1.18
FW Version: 3.0.1.17
4-48.
"-save (Save Host Configuration)"
Type: Copper
Type: Copper
Type: Copper
Type: Copper
"List All QLogic
5-15