Display Bios/Uefi [Or Fcode] Information (Cli Option -Binfo); Set Bios/Uefi [Or Fcode] Mode (Cli Option -Bootcodemode); Set Primary Boot Target Information (Cli Option -Pbootcode); Set Secondary Boot Target Information (Cli Option -Sbootcode) - Qlogic SANsurfer iSCSI HBA CLI User Manual

A
Display BIOS/UEFI [or FCode] Information
(CLI Option -binfo)
Select the Display BIOS/UEFI Information or Display FCode Information
option (this menu option varies depending on your system architecture) to view
information about the bootcode. For example:
BIOS Mode: Disabled (0x1)
BIOS Primary Target ID:
BIOS Secondary Target ID: 2
BIOS Vendor ID =
BIOS Alt Client ID = testod
BIOS Version: 1.14
BIOS Full Version: 1.14
Set BIOS/UEFI [or FCode] Mode
(CLI Option -bootcodemode
NOTE:
If the BIOS version is less than 1.04, this option is not supported (it displays
an error message).
Select the Set BIOS/UEFI Mode or Set FCode Mode option (depending on your
system architecture) to select the bootcode mode. For example:
Choose from one of the following modes:
1) BIOS/UEFI [or FCode] Boot Disabled
2) BIOS/UEFI [or FCode] Boot Manual Mode
3) BIOS/UEFI [or FCode] Boot DHCP-Root Path
For more information, refer to the parameters listed in
Set Primary Boot Target Information
(CLI Option -pbootcode)
Select the Set Primary Boot Target Information option to select the primary
target to boot from. At the prompt, type a target ID and associated LUN.
Set Secondary Boot Target Information
(CLI Option -sbootcode
Select the Set Secondary Boot Target Information option to select the
secondary target to boot from. At the prompt, type a target ID and associated
LUN.
SN0054621-00 E
)
)
4 – Interactive Mode Commands
Port Level Info & Operations Menu
2 LUN: 0
LUN: 0
C Target Parameters.
4-35