Update Firmware, Multiple Adapters; Install Hba Driver, All Adapters (Cli Option -D); Select Hba Port - Qlogic SANsurfer iSCSI HBA CLI User Manual

A
NOTE:
After you have selected the parameter sets to import, the following message
is displayed:
Resetting HBA This may take a few minutes.
After the HBA is reset, the HBA Import Menu reappears.

Update Firmware, Multiple Adapters

When you select the Update Firmware, Multiple Adapters option, SANsurfer
iSCSI HBA CLI prompts you to enter the file name of the new firmware. Be sure to
use full path names when specifying the new firmware file.
When finished typing the firmware file name and path, press ENTER.
Install HBA Driver, All Adapters
(CLI Option -d)
When you select the Install HBA Driver, All Adapters option, SANsurfer iSCSI
HBA CLI shows the current driver version and prompts you to enter the name of a
new driver. Be sure to use full path names when entering a new driver name.
Current driver version n.n.n.n for HBA Port: 0
Enter a driver file name or press <Enter> to return to Main Menu
Driver file:
When finished typing the driver name and path, press ENTER.

Select HBA Port

For information regarding this option, see
page 4-49.
SN0054621-00 E
Because the default is n (no), if you press ENTER after the prompt
n
without typing y or , you have essentially declined to import that
setting.
4 – Interactive Mode Commands
Host Level Info & Operations Menu
"Select HBA Port (No CLI Option)" on
4-11