Binfo (Display Bios/Uefi [Or Fcode] Information); Bootcode (Update Bios/Uefi [Or Fcode] Mode); Bootcodemode (Set Bios/Uefi [Or Fcode] Mode) - Qlogic SANsurfer iSCSI HBA CLI User Manual

5 – Non-Interactive Mode Commands
Non-interactive Commands
NOTES:
For information on the interactive version of this command
Option -b)" on page
-binfo
(Display BIOS/UEFI [or FCode] Information)
To display the bootcode settings for the specified HBA port, enter the -binfo
command as follows:
-binfo <hba_port_inst>
For information on the interactive version of this command, see
BIOS/UEFI [or FCode] Information (CLI Option -binfo)" on page
-bootcode
(Update BIOS/UEFI [or FCode] Mode)
Bootcode (that is, the bootable code image) is code that allows system boot from
an iSCSI drive.
The -bootcode command updates the bootcode code image, which should be
done when QLogic releases a new bootcode with bug fixes or enhancements. At
the prompt, type the name of the file containing the bootcode code image to
upload to the HBA.
For information on bootcode file names, see
Names.
To update the bootcode code image, enter the -bootcode command as follows:
-bootcode <hba_port_inst> <Bootcode Code Image File Name>
For information on the interactive version of this command, see
BIOS/UEFI [or FCode] Code Image (CLI Option -bootcode)" on page
-bootcodemode
(Set BIOS/UEFI [or FCode] Mode)
To set the bootmode mode for QLA4050, QLA4050C, QLE4060C, QLE4062, and
QMC4052 HBAs, enter the -bootcodemode command as follows:
-bootcodemode <hba_port_inst> <1>|<2>|<3>
5-4
Issuing this command resets both ports (0 and 1) on two-port HBAs.
You must disable bootcode mode to reset the HBA (see
(Set BIOS/UEFI [or FCode] Mode)" on page
4-14.
"-bootcodemode
5-4).
"HBA Reset (CLI
"Display
4-35.
Appendix E Downloadable File
"Update
SN0054621-00 E
S
4-13.