Table of Contents
Advertisement
4 – Interactive Mode Commands
Port Level Info & Operations Menu
4.
After making changes, refresh the HBA to show these changes by typing 6
(Refresh), and then pressing ENTER. If you do not select this option, your
changes will not be visible in SANsurfer iSCSI HBA CLI.
Ping Target
(CLI Option -ping)
To ping a target:
1.
On the Port Diagnostic Menu, type the number for the Ping option, and
then press ENTER.
SANsurfer iSCSI HBA CLI prompts you as follows:
Enter an IP Address:
2.
Type the target IP address, and then press ENTER.
SANsurfer iSCSI HBA CLI prompts you as follows:
Enter the number of PING attempts to make:
3.
Type a number between 1 and 2147483648 (2^31), and then press ENTER.
SANsurfer iSCSI HBA CLI prompts you as follows:
Enter the packet size in bytes for the PING [32]:
4.
Type the number you want.
For IPv6 networks, SANsurfer iSCSI HBA CLI prompts you as follows:
Which IPv6 address should be used as the source:
Type the number you want.
Here is an example of a successful ping attempt:
Ping to 10.14.64.153 successful <1 of 2>
Ping to 10.14.64.153 successful <2 of 2>
Press the Enter key to continue.
Here is an example of a ping on an IPv6 network:
Enter an IP Address:fe80::2a0:98ff:fe03:c98e
Enter the number of PING attempts to make:1
Enter the packet size in bytes for the PING [32]:
Which IPv6 address should be used as the source:
0 = Don't Care
1 = Link Local
2 = Address 0
3 = Address 1
4-30
0 = Don't Care
1 = Link Local
2 = Address 0
3 = Address 1
Enter Choice:1
S
SN0054621-00 E
Hide quick links:
Advertisement
Table of Contents
