Ping (Ping Target) - Qlogic SANsurfer iSCSI HBA CLI User Manual

A
-ping
(Ping Target)
To ping the target device specified IP address, enter the -ping command as
follows:
-ping <hba_port_inst> <IP Address> <Ping Count> <Packet size>
<IPv6 source address>
The following provides the IPv6 source address values:
Where:
For information on the interactive version of this command, see
Option -ping)" on page
-ps
To view persistent targets for the HBA port, enter the -ps command as follows:
-ps <hba_port_inst> [Target ID]
If you do not specify the [Target ID], SANsurfer iSCSI HBA CLI displays all
targets for the specified HBA port number. If you do not specify the port instance
[hba_port_inst] nor the Target ID, [Target ID], SANsurfer iSCSI HBA CLI
displays all target IDs for all HBA ports in the system.
There is no interactive command for this function.
-pu
To unbind a persistent target, enter the -pu command as follows:
-pu <hba_port_inst> <Target ID>
SN0054621-00 E
0 = Do Not Care
1 = Local Link
2 = Address 0
3 = Address 1
hba_port_inst = The HBA port that sends the ping.
IP Address = The IP address to pin.
Ping Count = The number of ping packets you want (1–[2^31]).
Packet Size = The size of the ping packet 0-64kB
= Origin device
IPv6 Source
Address
4-30.
5 – Non-Interactive Mode Commands
Non-interactive Commands
"Ping Target (CLI
5-25