Linkchap (Assign A Chap Entry To A Target); Model; N (Configure Iscsi Settings); Hba Parameters - Qlogic SANsurfer iSCSI HBA CLI User Manual

A
-linkchap
(Assign a CHAP Entry to a Target)
To link a CHAP entry to a target, enter the -linkchap command as follows:
-linkchap <hba_port_inst> <CHAP No.> <Target ID>
This command does not reset the HBA.
For information on the interactive version of this command
to a Target (CLI Option -linkchap)" on page
-lp
The IPv6 local prefix list is created based on prefix information from router
advertisements. Destination IP addresses containing these prefixes can be
reached directly, without going through an intermediate router.
To display the local prefix list, enter the -lp command as follows:
-lp <hba_port_inst>
There is no corresponding interactive mode option for this command.

-model

To view the HBA "model(s)" (board type[s]) in the system, enter the -model
command as follows:
-model
There is no corresponding interactive mode option for this command.
-n
(Configure iSCSI Settings)
To set to HBA iSCSI parameters for single port HBAs, enter the -n command as
follows:
-n <HBA No.> <Config Name|Config Alias> <Value>
[<Config Name|Config Alias> <Value> ...]
After you issue this command, the HBA is reset.
You can repeat the <Config Name|Config Alias> <Value> parameter set
for as many parameters as you want to configure.
and their ranges of values.
AFW_AutoConnect
SN0054621-00 E
Table 5-3. HBA Parameters
Configuration Name
5 – Non-Interactive Mode Commands
4-42.
Table 5-3
Configuration Alias
Add Firmware Options
AFWAC
Non-interactive Commands
"Assign a CHAP Entry
lists these parameters
Value
on or off
5-19