Clear Primary Boot Target Information (Cli Option -Cpbootcode); Clear Secondary Boot Target Information (Cli Option -Csbootcode); Set Alternative Client Id (Cli Option -Sbootcodecid); Target Level Info & Operations - Qlogic SANsurfer iSCSI HBA CLI User Manual

4 – Interactive Mode Commands
Port Level Info & Operations Menu
Clear Primary Boot Target Information
(CLI Option -cpbootcode)
Select the Clear Primary Boot Target Information option to disable the primary
boot target. At the prompt, type a target ID and associated LUN.
Clear Secondary Boot Target Information
(CLI Option -csbootcode)
Select the Clear Secondary Boot Target Information option to disable the
secondary boot target. At the prompt, type a target ID and associated LUN.
Set Alternative Client ID
(CLI Option -sbootcodecid)
Select the Set Alternative Client ID option to assign an optional alternative client
ID, which can be used in boot DHCP mode. The ID can be seven characters
maximum.
Target Level Info & Operations
Before making a selection from the HBA Target Menu, follow these steps:
1. Specify the HBA port whose settings you want to view or change by typing
the number for Select HBA Port, and then press ENTER.
A list of HBA ports is displayed.
2. Type the number for the HBA port whose settings you want to change, and
then press ENTER.
3. To make changes, select options from the following submenus:
10. Target Discovery Menu (see
11. List LUN Information (see
12. Save Target/CHAP Changes (see
13. Select HBA Port (see
14. Refresh (see
15. Exit (see
4-36
1. List Targets (see
2. Display Target Information (see
3. Bind Target (see
4. Delete Target (see
5. Configure Target Parameters (see
6. Add a Target (see
7. Disable a Target (see
8. Enable a Target (see
9. Configure Target Authentication Menu (CHAP) (see
page
page 4-50)
page 4-37)
page
page 4-39)
page 4-39)
page
page 4-40)
page 4-40)
page 4-40)
page 4-44)
page 4-47)
page
page 4-49)
4-49)
S
4-37)
4-39)
page
4-47)
SN0054621-00 E
4-40)