C (Display Configured Port Settings); Ch (Hba Information) - Qlogic SANsurfer iSCSI HBA CLI User Manual

A
Where:
If HBA DHCP is enabled (see
modes 1–3 are allowed. If HBA DHCP is not enabled, bootcode DHCP is not
allowed. This mode is not supported for QLA4010 HBAs. This mode is not active
for the PPC.
For IBM cards, the following modes are available:
For information on the interactive version of this command, see
[or FCode] Mode (CLI Option -bootcodemode)" on page
NOTE:
Bootcode DHCP is not allowed for QLA4010 HBAs.
-c
(Display Configured Port Settings)
To view the configured settings for the port, enter the -c command as follows:
-c [hba_port_inst]
When you specify a port instance, information for only that HBA is shown. When
you do not specify a port instance, information for all HBA ports in the system is
shown.
For a list of HBA settings, see
on page 4-22
-ch
(HBA Information)
To display the HBA's configured settings, enter the -ch command as follows:
-ch [hba_port_inst]
When you specify a port instance, information for only that HBA is shown. When
you do not specify a port instance, information for all HBA ports in the system is
shown.
SN0054621-00 E
1 = Disabled
2 = Manual mode
3 = DHCP–Root path
"-ipdhcp (Configure IP Settings)" on page
4 = DHCP Vendor ID
5 = DHCP-Auto
6 = Auto
7 = System Mode
"Display Configured Port Settings (CLI Option -c)"
and Appendix C Target
5 – Non-Interactive Mode Commands
Non-interactive Commands
4-35.
Parameters.
5-16),
"Set BIOS/UEFI
5-5