Ipdhcp (Configure Ip Settings); Isns (Configure Isns Settings) - Qlogic SANsurfer iSCSI HBA CLI User Manual

5 – Non-Interactive Mode Commands
Non-interactive Commands
For information on the interactive version of this command, see
Configuration (CLI Option -import)" on page
-ipdhcp
(Configure IP Settings)
To set the HBA to get its IP address, subnet mask, and gateway from the DHCP
server, enter the -ipdhcp command as follows:
-ipdhcp <hba_port_inst> [-option]
If the HBA port had prior values set manually, the DHCP values replace them.
Where [option] includes:
For information on the interactive version of this command, see
Settings (CLI Option -ipdhcp)" on page
-isns
(Configure iSNS Settings)
To configure the iSNS settings for QLA4010 and QLA405x, enter the -isns
command as follows:
5-16
I = Configure the iSCSI name.
T = Configure the targets.
C = Configure the CHAP table.
B = Configure the boot parameters. (only valid when T [tar-
gets] parameter is also specified).
Filename = The XML file with the HBA configuration. See
(Save Host Configuration)" on page
-DISN4 = Disable IPv4 network
-IPV4DHCP = Set DHCP ON
-IP = Set IP Address
-IPNM = Set IP Netmask
-IPGW = Set IP Gateway
-DISN6 = Disable IPv6 Network Setup
-IPLLA = Set Local link Address Automatically
-IPLL = Set Local link Address Manually
-IPRA = Set IPR0 and IPR1 Automatically
-IPR0 = Set Routable Address 0 Manually
-IPR1 = Set Routable Address 1 Manually
-IPRAA = Set Router Address Automatically
-IPRR = Set Router Address Manually
5-28).
4-10.
4-21.
S
"-save
"Import HBA
"Configure IP
SN0054621-00 E