Display Configured Link Configuration (Cli Option -Lcd); Configure Link Configuration (Cli Option -Lc); Save Changes And Reset Hba (If Necessary); Port Network Settings Menu - Qlogic SANsurfer iSCSI HBA CLI User Manual

4 – Interactive Mode Commands
Port Level Info & Operations Menu
Display Configured Link Configuration
(CLI Option -lcd)
Select the Display Configured Link Configuration option to view the following
information about the configured link:
Portal Flow Control
Auto-negotiate link speed: (on or off)
Link Speed
Configure Link Configuration
(CLI Option -lc)
Select the Configure Link Configuration option to view and modify each of the
configurable link settings, including:
Auto-negotiate link speed
Flow Control
The current setting (on or off) is shown in brackets. To change a setting, type on
or off, and then press ENTER.

Save Changes and Reset HBA (if necessary)

Before resetting the HBA, ensure no connections are active. Select the Save
Changes and Reset HBA option to save your changes and reset all ports on the
HBA.

Port Network Settings Menu

The Port Network Settings Menu options include the following:
1. Display Network Settings (see
2. Configure IP Settings (see
3. iSNS Settings (see
4. Select HBA Port (see
5. Save Changes and Reset HBA (see
6. Refresh (see
7. Exit (see
Display Network Settings
(
CLI Options -netconf)
Select the Display Network Settings option to view the settings for dynamic host
configuration protocol (DHCP), link local address, IPv6, and iSNS. For example:
Using DHCP to obtain an IP Addresses.
IPv4 Address
Gateway
Subnet Mask
4-20
: (on or off)
: (in Mbs)
page 4-21)
page 4-49)
page 4-49)
page 4-50)
: 10.14.65.19
: 10.14.64.1
: 255.255.254.0
page 4-20)
page 4-21)
page 4-18)
S
SN0054621-00 E