Nh (Configure Iscsi Settings); Pa (Add A Target) - Qlogic SANsurfer iSCSI HBA CLI User Manual

A
To set only the local link address, enter the following:
-netconf6 0 -IPLL fe80::1
To set everything automatically, enter the following:
-netconf6 0 -IPLLA -IPR01A -IPRRA
To disable the IPv4 network, enter the following:
-netconf6 0 -DISN4
To disables the IPv4 and IPv6 networks:
-netconf6 0 -DISN4 DISN6
For information on the interactive version of this command, see
Settings (CLI Options -netconf, -netconf6, -isns, -isns6, -ip, and -nc)" on
page 4-27.
-nh
(Configure iSCSI Settings)
To set the HBA level parameters for multiport HBAs, enter the -nh command as
follows:
-nh <hba_port_inst> <Config name | Config alias> <Value>
[<<Config name | Config alias>> <Value> ...]
The valid parameters and their values are shown in
of HBA parameters, see
For information on the interactive version of this command, see
Settings (CLI Options -n and -nh)" on page
-pa
(Add a Target)
To add persistent targets, enter the -pa command as follows:
-pa <hba_port_inst> <IP Address> [-PORT port number] [-INAME iSCSI
Name]
If you do not specify a port number
HBA CLI uses the default number 3260. If you do not specify an iSCSI name,
[-INAME iSCSI Name] SANsurfer iSCSI HBA CLI uses the default value, an
empty string.
For information on the interactive version of this command, see
Option -pa)" on page
SN0054621-00 E
Appendix C Target
[-PORT
4-40.
5 – Non-Interactive Mode Commands
Non-interactive Commands
"Configure IPv6
Table 5-3. For a complete list
Parameters.
"Configure iSCSI
4-24.
, SANsurfer iSCSI
port number
]
"Add a Target (CLI
5-23