Port- And Hba-Level Parameters; Port-Level Parameters; A-1 Port Settings - Qlogic SANsurfer iSCSI HBA CLI User Manual

A
Port- and HBA-level
Parameters
The tables in this appendix list the following types of SANsurfer iSCSI HBA CLI
parameters:

Port-level Parameters

HBA-level Parameters
Port-level Parameters
Table A-1
parameters, both configurable and non-configurable (read-only), use the -c
option in non-interactive mode. To edit configurable parameters, use the -n option
in non-interactive mode.
NOTE:
The parameters in this table are sorted alphabetically for ease of use.
Parameter
AFW_AutoConnect
AFW_Delayed_Ack
AFW_Device_Timeout
SN0054621-00 E
(see page
lists the HBA port firmware parameters and their values. To view all
Table A-1. Port Settings
Value Alias
on, off AFWC
on, off AFDACK
on, off AFWDT
A-10)
Description
When on, the HBA will not try to autoconnect to
the configured targets at boot time. Instead, the
host must issue Set Device Database Entry
commands (0063h) to establish connections to
targets.
Determines what occurs when the HBA receives
a Data-In PDU with the Final bit set and no sta-
tus reported. When on, the HBA sends a TCP
acknowledgment immediately (this is the default
value). When this parameter is off, the HBA
delays the acknowledgment and waits for more
data.
When on, the HBA firmware ignores the IOCB
command timeout values specified by the host.
A-1