G (Display General System Information); Gcr (Retrieve Fw Crash Record); H (Help) - Qlogic SANsurfer iSCSI HBA CLI User Manual

A
-fa <Filename>
For example if the image is for a QLA4010, all QLA4010s are updated, and no
other HBAs. (Newer images may be appropriate for both QLA405x and QLA406x
type HBAs.) Issuing this command resets all updated HBAs.
For information on the interactive version of this command, see
Image (CLI Option -f)" on page
-g
(Display General System Information)
To view general system information, enter the -g command as follows:
-g
SANsurfer iSCSI HBA CLI shows the following:
Host name
Host version
Host type
User type
For information on the interactive version of this command, see
System Information (CLI Option -g)" on page
-gcr
(Retrieve FW Crash Record)
To get crash record information for the specified HBA port, enter the -gcr
command as follows:
-gcr <hba_port_inst> <Crash Output File>
For information on the interactive version of this command, see
Crash Record (CLI Option -gcr)" on page
-h
(Help)
To view the SANsurfer iSCSI HBA CLI help file, enter the -h command as follows:
-h
For convenience, you can send the output to a file for easier viewing or printing as
follows:
Iscli –h >file.txt
For information on the interactive version of this command, see
-h)" on page
SN0054621-00 E
4-13.
4-49.
5 – Non-Interactive Mode Commands
Non-interactive Commands
4-9.
4-15.
"Update Firmware
"Display General
"Retrieve FW
"Help (CLI Option
5-13