Chapmap (Display Targets Using Chap Entries); Cpbootcode (Clear Primary Boot Target Information); Csbootcode (Clear Secondary Boot Target Information); D (Install Hba Driver, All Adapters) - Qlogic SANsurfer iSCSI HBA CLI User Manual

5 – Non-Interactive Mode Commands
Non-interactive Commands
For a list of HBA settings, see
parameters, see
For information on the interactive version of this command, see
(CLI Option -ch)" on page
-chapmap
(Display Targets Using CHAP Entries)
To display the map of targets to CHAP table entries, enter the -chapmap
command as follows:
-chapmap <hba_port_inst>
For information on the interactive version of this command, see
Using CHAP Entries (CLI Option -chapmap)" on page
-cpbootcode
(Clear Primary Boot Target Information)
To clear the primary boot target and LUN, enter the -cpbootcode command as
follows:
-cpbootcode <hba_port_inst>
For information on the interactive version of this command, see
Boot Target Information (CLI Option -cpbootcode)" on page
NOTE:
This command is not active for the PPC.
-csbootcode
(Clear Secondary Boot Target Information)
To clear the secondary boot target and LUN, enter the -csbootcode command
as follows:
-csbootcode <hba_port_inst>
For information on the interactive version of this command, see
Boot Target Information (CLI Option -csbootcode)" on page
-d
(Install HBA Driver, All Adapters)
To install an HBA driver for all iSCSI HBAs on the system from a .zip or .inf
file, enter the -d command as follows:
-d <File Name>
A system reboot may be required; see the log file for details.
5-6
Table 5-3 on page
Appendix C Target Parameters.
4-12.
5-19. For a complete list of HBA
"HBA Information
"Display Targets
4-41.
"Clear Primary
4-36.
"Clear Secondary
4-36.
SN0054621-00 E
S