Table of Contents
Advertisement
B – Command Line Interface
Show Command
port [port_number]
Displays operational information for the port given by [port_number]. Ports are
numbered beginning with 0. If [port number] is omitted, information is displayed for
all ports.
AIinit
AIinitError
Bad Frames
ClassXFramesIn
ClassXFramesOut
ClassXWordsIn
ClassXWordsOut
ClassXToss
DecodeError
EpConnects
FBusy
Flowerrors
FReject
InvalidCRC
InvalidDestAddr
LIP_AL_PD_ALPS
LIP_F7_AL_PS
B-90
Table B-27
describes the port parameters.
Table B-27. Show Port Parameters
Entry
Incremented each time the port begins AL initialization.
Number of times the port entered initialization and the
initialization failed.
Number of frames that have framing errors.
Number of class x frames received by this port.
Number of class x frames sent by this port.
Number of class x words received by this port.
Number of class x words sent by this port.
Number of times an SOFi3 or SOFn3 frame is tossed from
TBUF.
Number of decode errors detected
Number of times an E_Port connected through ISL negotiation.
Number of times the switch sent a F_BSY because Class 2
frame could not be delivered within ED_TOV time. Number of
class 2 and class 3 fabric busy (F_BSY) frames generated by
this port in response to incoming frames. This usually indicates
a busy condition on the fabric or N_Port that is preventing
delivery of this frame.
Received a frame when there were no available credits.
Number of frames from devices that were rejected.
Invalid CRC detected.
Invalid destination address detected.
Number of F7, AL_PS LIPs, or AL_PD (vendor specific) resets,
performed.
This LIP is used to reinitialize the loop. An L_Port, identified by
AL_PS, may have noticed a performance degradation and is
trying to restore the loop.
Description
0
59042-08 A
Advertisement
Table of Contents
