Table of Contents
Advertisement
0
pagebreak [state]
Specifies how much information is displayed on the screen at a time according to
the value given by [state]. This keyword does not require an admin session. [state]
can be one of the following:
on
Limits the display of information to 20 lines at a time. The page break
functions affects the following commands: Alias (List, Members), Show
(Alarm, Log), Zone (List, Members), Zoneset (List, Zones), Zoning (Active,
List).
off
Allows continuous display of information without a break.
port [option]
Sets port state and speed for the specified port. The previous Set Config Port
settings are restored after a switch reset or a reactivation of a switch
configuration. Refer to the
setup [option]
Changes SNMP and system configuration settings. Refer to the
Command" on page
switch [state]
Changes the administrative state for all ports on the switch to the state given by
[state]. The previous Set Config Switch settings are restored after a switch reset
or a reactivation of a switch configuration. [state] can be one of the following:
online
Places all ports online
offline
Places all ports offline.
diagnostics
Prepares all ports for testing.
timezone
Specifies the time zone for the switch and the workstation. The default is Universal
Time (UTC) also known as Greenwich Mean Time (GMT). This keyword prompts
you to choose a region, then a subregion to specify the time zone.
Examples
The following examples enables and disables the beacon:
SANbox2 #> set beacon on
Command succeeded.
SANbox2 $> set beacon off
Command succeeded.
59042-08 A
"Set Port Command" on page
B-77.
B – Command Line Interface
Set Command
B-75.
"Set Setup
B-59
Advertisement
Table of Contents
