Table of Contents
Advertisement
0
SymPortName
ALFairness
DeviceScanEnable (True / False)
ForceOfflineRSCN (True / False)
ARB_FF
InteropCredit (decimal value, 0-255)
ExtCredit
FANEnable
AutoPerfTuning (True / False)
LCFEnable
MFSEnable
VIEnable
MSEnable
NoClose
IOStreamGuard (Enable / Disable / Auto)
PDISCPingEnable
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
SANbox2 (admin-config) #>
The following is an example of the Set Config Security command:
SANbox2 #> admin start
SANbox2 (admin) #> config edit
SANbox2 (admin-config) #> set config security
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
FabricBindingEnabled
AutoSave
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
59042-08 A
(string, max=32 chars)
(True / False)
(True / False)
(dec value, increments of 11, non-loop only)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
B – Command Line Interface
Set Config Command
[False]
[True ]
[Port1 ]
[False ]
[True
]
[False ]
[False ]
[0
]
[0
]
[True
]
[False ]
[False ]
[False ]
[False ]
[True
]
[False ]
[Disable]
[True
]
B-67
Advertisement
Table of Contents
Need help?
Do you have a question about the SANbox2-8c and is the answer not in the manual?
Questions and answers