B-5 Isl Group Member Attributes - Qlogic SANbox2-8c Installation Manual

0
Keywords
add [group]
Initiates an editing session in which to specify a group member and its attributes
for the existing group given by [group]. ISL, Port, and MS member attributes are
described in
and group type attributes are read-only fields common to all three tables.
Attribute
Member
Authentication
Primary Hash
Primary
Secret
Secondary
Hash
Secondary
Secret
Binding
59042-08 A
Table B-5, Table B-6, and
Table B-5. ISL Group Member Attributes
Worldwide name of the switch that would attach to the switch. A
member cannot belong to more than one group.
Enables (CHAP) or disables (None) authentication using the
Challenge Handshake Authentication Protocol (CHAP). The
default is None.
The preferred hash function to use to decipher the encrypted
Primary Secret sent by the ISL member. The hash functions are
MD5 or SHA-1. If the ISL member does not support the Primary
Hash, the switch will use the Secondary Hash.
Hexadecimal string that is encrypted by the Primary Hash for
authentication with the ISL group member. The string has the
following lengths depending on the Primary Hash function:
MD5 hash: 16-byte
SHA-1 hash: 20-byte
Hash function to use to decipher the encrypted Secondary Secret
sent by the ISL group member. Hash values are MD5 or SHA-1.
The Secondary Hash is used when the Primary Hash is not
available on the ISL group member. The Primary Hash and the
Secondary Hash cannot be the same.
Hex string that is encrypted by the Secondary Hash and sent for
authentication. The string has the following lengths depending on
the Secondary Hash function:
MD5 hash: 16-byte
SHA-1 hash: 20-byte
Domain ID of the switch to which to bind the ISL group member
worldwide name. This option is available only if
FabricBindingEnabled is set to True using the Set Config Security
command. Refer to the
0 (zero) specifies no binding.
B – Command Line Interface
Table B-7 respectively. The group name
Description
"Set Config Command" on page
Group Command
B-60.
B-25