Table of Contents
Advertisement
5 – Diagnostics/Troubleshooting
POST Diagnostics
6.
When the recreate process is complete, select option 7 to reset the switch
and exit maintenance mode.
7.
If a previously saved configuration file is available for the switch, do the
following to restore the configuration file.
a.
b.
c.
d.
e.
f.
g.
h.
5-4
Establish communications with the switch using the File Transfer
Protocol (FTP) by entering the following on the command line:
>ftp 10.0.0.1
Enter the following account name and password:
user:images
password:images
Activate binary mode and copy the configuration file from the
workstation to the switch. The configuration file must be named
"configdata".
ftp>bin
ftp>put configdata
Close the FTP session.
ftp>quit
Establish communications with the switch using Telnet. Enter one of
the following on the command line:
telnet xxx.xxx.xxx.xxx
or
telnet switchname
where xxx.xxx.xxx.xxx is the switch IP address and switchname is the
switch name associated with the IP address.
A Telnet window opens prompting you for a login. Enter an account
name and password. The default account name and password are
(admin, password).
Open an admin session to acquire the necessary authority.
SANbox2 $>admin start
Restore the configuration file. When the restore is complete, the switch
will reset.
SANbox2 (admin) $>config restore
0
59042-08 A
Advertisement
Table of Contents
