Qlogic Fibre Channel Switch Event Message Manual page 30

3 – Event Messages
Alarm Events
(A3008.2000) (The configuration area was damaged or a Remake Filesystem was
performed from PROM mode. You must perform a 'config restore' to clear
this error.)
Meaning:
Action:
(A3014.0001) (Blade in slot
Meaning:
Action:
(A3014.0002) (Blade in slot
Meaning:
Action:
(A6000.0002) (Configured port speed for port
Meaning:
Action:
(A6001.0001) (cmon: insufficient memory)
Meaning:
Action:
3-18
The configuration area was damaged or a Remake Filesystem was
performed from Maintenance mode.
Enter the Config Restore command to clear the error. If this does
not correct the problem, contact your authorized maintenance
provider.
set Down due to failure of all AuxPorts)
slot_number
The blade in the named slot has isolated because all auxiliary ports
to the cross-connect blades have failed.
Contact your authorized maintenance provider.
set Online due to internal failure recovery)
slot_number
The blade in the named slot has recovered at least one auxiliary
port to a cross-connect blade and is no longer isolated.
None
port_number
The transceiver in the named port is not capable of transmitting at
the configured port speed.
Reconfigure the port speed or replace the transceiver.
The Hotreset command has failed due to insufficient memory on
the switch. The switch has been returned to its state before the
Hotreset command was entered.
If acceptable, enter the Reset Switch command to reboot the
switch. Contact technical support if a non-disruptive code load and
activation is required.
not compatible with media.)
A
59060-01 B